Instructions for the FT Wafer Trap

1) Assembling and Deploying the FT Wafer Trap

2) Retreiving the FT Wafer Trap

 

 

Assembling and Deploying the FT Wafer Trap

 

STEP No. 1

  

  • Hold the trap facing the side without the adheasive.

  • •Fold the upper side flaps •(OUT SIDE FOLD FIRST)

  • •Run  your thumbs  from top to bottom.

    Back to Top

STEP No. 2
  
  • •Fold the upper side flaps, (IN SIDE FOLD)
  • •Run your thumbs from  bottom to  top.

    Back to Top

SIDE FLAPS ARE FOLDED

Back to Top

STEP No. 3

  

  • •Fold the trap in half.
  • •Pre-fold the top flap.
  • •Locate your fingers as shown in the picture.
  • •Peel the release paper up and out, (half way only) with a single pull.
  • •Fold the top flap

    Back to Top

STEP No. 4

     

  • Reposition the release paper as shown.

Back to Top

STEP No. 5

   

  • •Insert the wafer into the trap.
  • •Install the wire hanger.

    Back to Top

STEP No. 6

  • •Holding the trap as shown in the picture,(your thumb inside the trap).
  • •Pull the release paper up and out with one single pull.

    Back to Top

STEP No. 7

  • •Hold the trap as shown,(place your fingers inside the trap).
  • •Pull the release paper up and out with one single pull. 

    Back to Top

The Trap is Ready!

Back to Top

 

 

Retrieving the FT Wafer Trap

 

STEP No. 1

  

  • Remove the trap from the branch.
  • Remove the paper clips and the hanger.
  • Pull the zipper to tear it off as shown.

STEP No. 2

      

  • Facing the glue side of the trap fold the side flaps as shown.

Back to Top

STEP No. 3

  • Fold the trap in half, and use the paper clips to hold it together 

Back to Top